Noticed underneath leaking for a while, finally bought this O-Ring part from Honda dealer for $2.52 while doing something else.
20170522-accordoring1.jpg
Remove the spark plugs from the tubes instead of the distributor cap, this way, I won't be confused about which cable going where.
Then removed 3 bolts holding the distributor, the inner bottom one fell off, need some long needle pliers to pick up, so be very careful. Put a paper towel under the distributor to absorb any spill. Loosened up the distributor by twisting it and pulled it out.
20170522-accordoring2.jpg
Marked the tip of the crescent shape with a Sharpie to preserve timing, this is very critical in order not to mess up the engine. Cleaned up the leak and surrounding area with paper towels. Used a small flat screw driver to get the old O-Ring out, it is very fragile already, so it was broken when pried on. Put on the new one with ease while there was still engine oil around the axle and itself being flexible.
20170522-accordoring3.jpg
Made sure the marks lined up, then put it back in, and twist a little bit until it is full engaged. Should had put the inner bottom bolt in first, because it slipped again and needed to unscrew and pull the distributor back out to pick that bolt. Otherwise, it is an fairly easy job and saves you quite some sweet bucks.
20170522-accordoring4.jpg